This article mainly introduces:

Australia hydraulic cylinder,vehicle hydraulic cylinder manufacturer,vehicle hydraulic cylinder

(Australia vehicle hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

vehicle hydraulic cylinder are widely used in Australia，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed vehicle hydraulic cylinder for customers from Australia.

Introduction to vehicle hydraulic cylinder:

The difference between the plunger vehicle hydraulic cylinder and the piston vehicle hydraulic cylinder is that the piston in the vehicle hydraulic cylinder is replaced by a shaft plunger, which is used in hydraulic transmission requiring a long mechanical stroke, and can only input pressure oil from one direction, pressurize in a single direction, and form a thrust to push the plunger to move. The return trip of the plunger depends on the plunger itself to fall, and some rely on the spring to push back to the original position. Usually used plunger type vehicle hydraulic cylinder, its inner hole does not need mechanical finishing, as long as the plunger round grinding can be assembled.

The vehicle hydraulic cylinder should be used correctly and maintained regularly. The vehicle hydraulic cylinder should be deflated before use, the buffer regulating valve should be adjusted to a reasonable position, the cleanliness of the oil should be checked regularly, the dust on the vehicle hydraulic cylinder should be cleaned regularly, and attention should be paid to waterproof and fireproof.

vehicle hydraulic cylinder piston rod material introduction: In general, we use 45 steel to produce vehicle hydraulic cylinder piston rod. It has a large impact force when it is used, and some good performance steel are also used in the heavy load transmission. In order to have enough work intensity when using, and can ensure normal use, this is still more critical to have a detailed understanding of the material.

Because of the slightly complex structure of the buffer vehicle hydraulic cylinder, sometimes there will be problems, such as when the vehicle hydraulic cylinder with the buffer device is started in reverse, the piston often stops temporarily or reverses. Elimination method: The orifice of the check valve is too small, so that the amount of oil entering the buffer chamber is too small, and even a vacuum occurs, so the above fault phenomenon will occur when the buffer plunger leaves the end cover. In this regard, the orifice of the check valve should be increased.

Answers to some questions about vehicle hydraulic cylinder:

What steel pipe does hydraulic cylinder use? This problem is very general. Carbon steel pipe or ordinary seamless steel pipe are all ok, but then there are rolling, quilting, heat treatment and other steps, and the requirements are different, the wall thickness is different, the material is different. It depends on the circumstances.

What are the functions of hydraulic cylinders?
Hydraulic cylinder is a hydraulic actuator, the specific role depends on the installation occasion and the type of hydraulic cylinder. Hydraulic cylinder is mainly used in machinery, and it is the most important component of construction machinery. It is important core component which mainly provide power for machinery.