This article mainly introduces:

Uruguay hydraulic cylinder,stern plate hydraulic cylinder manufacturer,stern plate hydraulic cylinder

(Uruguay stern plate hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

stern plate hydraulic cylinder are widely used in Uruguay，because of long service life，smooth movement，high work efficiency.So our company has designed stern plate hydraulic cylinder for customers from Uruguay.

Introduction to stern plate hydraulic cylinder:

Most of the failure of the stern plate hydraulic cylinder is because there is a foreign body in the stern plate hydraulic cylinder into the failure of the stern plate hydraulic cylinder, the most problematic is that it is difficult to determine when the foreign body is into the stern plate hydraulic cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

When the stern plate hydraulic cylinder is installed on the main engine, the oil port piping part and the guide sleeve should be checked for oil leakage in the running test, and the earring and the middle hinge shaft bearing should be refueled.

The main role of the stern plate hydraulic cylinder: the stern plate hydraulic cylinder is an executive element in the hydraulic transmission system, which is an energy conversion device that converts hydraulic energy into mechanical energy. The hydraulic motor realizes continuous rotary motion, while the stern plate hydraulic cylinder realizes reciprocating motion. The structure of the stern plate hydraulic cylinder has three categories: piston stern plate hydraulic cylinder, plunger stern plate hydraulic cylinder, swing stern plate hydraulic cylinder, piston stern plate hydraulic cylinder and plunger stern plate hydraulic cylinder to achieve reciprocating linear motion, output speed and thrust, swing stern plate hydraulic cylinder to achieve reciprocating swing, output angular speed (speed) and torque. In addition to the single use of the stern plate hydraulic cylinder, two or more can be combined or used in combination with other mechanisms. To fulfill a special function. The stern plate hydraulic cylinder has simple structure and reliable operation, and has been widely used in the hydraulic system of machine tools.

How to determine the working pressure of the stern plate hydraulic cylinder: The pressure depends on the load size (i.e., F) and the type of equipment. The limitations of assembly space, economic conditions and component availability of the actuator should also be considered. In the case of a certain load, it is necessary to increase the structural size of the actuator if the working pressure is low, for some equipment, the size may be limited, and it is not economical from the point of view of material consumption; On the contrary, if the pressure selection is too high, the material, sealing and manufacturing accuracy of the pump, stern plate hydraulic cylinder, valve and other components are also required to be high, which will inevitably increase the cost of equipment. In general, for equipment with a fixed size that is not too limited, the pressure can be selected lower, and the walking machinery should be selected higher.

Answers to some questions about stern plate hydraulic cylinder:

Can multiple identical hydraulic cylinders be supplied with the same supply line?
This can be connected, but there is a disadvantage, that is, the hydraulic cylinder with the minimum pressure is extended first, and then the pressure is higher, and then the higher, until all the hydraulic cylinders are extended, which may not meet the requirements of field use.

What is the cylinder with rod cavity, what is the rodless cavity.
The rod cavity is the end of the piston rod, the rodless cavity is the end without the piston rod.