This article mainly introduces:

Korea hydraulic cylinder,reciprocating cylinder manufacturer,reciprocating cylinder

(Korea reciprocating cylinder,produced by Hengyu Hydraulic Co., Ltd）

reciprocating cylinder are widely used in Korea，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed reciprocating cylinder for customers from Korea.

Introduction to reciprocating cylinder:

If the seal of the reciprocating cylinder is abnormal wear, you can check whether the speed control valve is improperly adjusted, resulting in too high back pressure and improper installation of the seal or hydraulic oil contamination. The second is whether there is a foreign body entering the assembly and the quality of the sealing material is not good. The result is that the action is slow and weak, and in serious cases, it will cause damage to the piston and reciprocating cylinder, and the phenomenon of "pulling the reciprocating cylinder" appears. The treatment method is to adjust the speed control valve, and the necessary operation and improvement should be done according to the installation instructions.

The repair method of the reciprocating cylinder: the repair of the reciprocating cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.

The piston seal of the reciprocating cylinder is the main element to prevent leakage in the reciprocating cylinder. For the lip seal, it should focus on checking whether the lip edge is bruised and worn, and for the combination seal, it should focus on checking the wear of the sealing surface, and then determine whether the seal can be used. In addition, it is necessary to check whether the static seal between the piston and the piston rod is crushed. The piston rod seal should focus on checking the wear of the seals and supporting rings.

Protection of the reciprocating cylinder surface: During the dismantling process, safety protection should be carried out on the reciprocating cylinder to prevent objects from falling and welding slag from falling to the surface, causing damage to the reciprocating cylinder surface. In the process of propulsion, the damaged pipe segments should be prevented from falling and smashing, and the slurry remaining on the surface of the reciprocating cylinder should be cleaned up in time.

Answers to some questions about reciprocating cylinder:

The two cylinders of the bending machine are out of sync?
Check whether the sliding slide is worn, adjust its tightness, so that both sides are consistent, check whether the two cylinder tubing is connected, tighten the flow valve, pressure, let the cylinder air discharge.

The cylinder is moving too fast. I want to slow it down. What can I do?
The hydraulic cylinder is the execution action, and the power source is the hydraulic system. The cylinder speed is too fast, indicating that the system flow is large, the hydraulic system has a hydraulic valve responsible for speed control function, method: 1, by adjusting the speed control valve to reduce the speed; 2, the speed control valve has been adjusted to the lowest, indicating that the hydraulic system design flow is too high, the need to re-configure the hydraulic system according to demand, or the cylinder diameter is changed.