This article mainly introduces:

Kenya hydraulic cylinder,stroke adjustable cylinder manufacturer,stroke adjustable cylinder

(Kenya stroke adjustable cylinder,produced by Hengyu Group）

stroke adjustable cylinder are widely used in Kenya，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed stroke adjustable cylinder for customers from Kenya.

Introduction to stroke adjustable cylinder:

The daily inspection of the stroke adjustable cylinder includes: checking the connection of the stroke adjustable cylinder and the pipe joint for leaks. Check the stroke adjustable cylinder rod for leaks. Check the stroke adjustable cylinder connection for leaks. When the stroke adjustable cylinder moves, the work is normal and smooth. Whether the stroke adjustable cylinder has internal leakage.

The meaning of the stroke adjustable cylinder model marked by the stroke adjustable cylinder manufacturer: for example, 160/100-1150, its meaning: from a professional point of view, 160 refers to the stroke adjustable cylinder diameter, which is 160mm, and the 100 behind refers to the rod diameter, which is 100mm. The 1150 refers to the stroke adjustable cylinder stroke, which is 1150mm. Therefore, on this point, we should have a correct understanding and can not make mistakes.

Causes and countermeasures of oil stroke adjustable cylinder leakage: Cast iron ring seal allows a certain degree of internal leakage. The impurities in the stroke adjustable cylinder will lead to premature wear of the piston seal, replace the piston seal; If the stroke adjustable cylinder is visibly scarred, the stroke adjustable cylinder must be replaced. It can be pressurized at one end of the stroke adjustable cylinder and opened at the other end of the oil port to observe whether there is obvious internal leakage at the end of the oil port. Most stroke adjustable cylinder piston drift may not come from the stroke adjustable cylinder, the above method to determine the stroke adjustable cylinder without internal leakage is helpful to determine the problem of the hydraulic system related components.

In order to ensure the service life of the stroke adjustable cylinder, the hydraulic system must be set up effective filtration to prevent pollution, the cleanliness of the oil should meet the ISO4406 standard, and the quality of the filtration should also meet the corresponding standards in ISO. The grade requirements of the filter are performed according to the actual working conditions of the system, but the minimum requirements are not less than 19/15 in ISO4406, that is, 24μ (β10≥75) in ISO4572.

Answers to some questions about stroke adjustable cylinder:

How to disassemble the big nut that excavate the oil cylinder piston of the excavator?
If you want to be safe, look for a special unloading place for this thing, which is an oil cylinder on top of a turntable with a large nut attached to the center of the turntable. If you're in the field just pin the head of the cylinder to one end, use a big homemade wrench to hold the nut in place, and then get a digging machine and push it down, and it opens.

How to calculate the hydraulic cylinder pressure, how much pressure can put up how much weight?
There is a formula for air pressure, hydraulic pressure, water pressure: F=P×S type: f-cylinder or hydraulic cylinder output, unit is Newton (N) P- pressure, unit is Mpa S- effective area, unit is square millimeter (mm2), note: is the effective area, in the hydraulic cylinder to subtract the cross-sectional area of the piston rod.