This article mainly introduces:

Guatemala hydraulic cylinder,tension cylinder manufacturer,tension cylinder

(Guatemala tension cylinder,produced by Hengyu Hydraulic Cylinder Factory）

tension cylinder are widely used in Guatemala，because of smooth movement，high work efficiency，clever hydraulic energy conversion.So our company has designed tension cylinder for customers from Guatemala.

Introduction to tension cylinder:

The repair method of the tension cylinder: the repair of the tension cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.

When installing the tension cylinder, the axial ends of the tension cylinder cannot be fixed. Due to the effect of liquid pressure and thermal expansion in the tension cylinder, there is axial expansion. If the two ends of the tension cylinder are fixed, all parts of the tension cylinder will be deformed. When disassembling the tension cylinder, it is strictly forbidden to hammer the tension cylinder and the piston surface, such as the tension cylinder hole and the piston surface is damaged, do not allow sandpaper grinding, to use a fine oil stone carefully grinding. The clearance between the guide sleeve and the piston rod should meet the requirements.

The body of the tension cylinder on the processing process requirements: the body of the tension cylinder is an important and essential part of the tension cylinder, because it has an irreplaceable role. The processing requirements for this part are very high, requiring that the surface roughness of the tension cylinder after processing should reach 0.4-0.8um, and the coaxiality and wear resistance requirements are also very high.

The repair method of tension cylinder wear: 1. Metal repair material is applied to the scratched surface; The first layer should be thin, uniform and fully covered with the scratched surface to ensure the best adhesion between the material and the metal surface, and then apply the material to the entire repair site and press repeatedly to ensure that the material is filled and reaches the required thickness, so that it is slightly higher than the surface of the guide rail; 2, the material at 24℃ to fully achieve the performance of 24 hours, in order to save time, can be through the tungsten halogen lamp to increase the temperature, the temperature rises 11℃, the curing time will be reduced by half, the best curing temperature 70℃; 3. After the material is cured, use a fine grinding stone or a scraper to repair and smooth the material higher than the surface of the guide rail, and the construction is completed.

Answers to some questions about tension cylinder:

How to calculate the cross-sectional area of hydraulic cylinder?
Hydraulic cylinder cross section integral rod cavity and rodless cavity: rod cavity is cylinder inner wall cross-sectional area - piston rod cross-sectional area; The rodless cavity is the cross-sectional area of the inner wall of the cylinder. If the working pressure p and the output force F are known, the effective cross-sectional area A=F/p can be calculated.

What is the meaning of cylinder ejection on the injection mold, and what is the difference between cylinder ejection and ordinary ejection?
Usually requires the front die ejection will use the cylinder to drive the thimble plate to achieve the ejection of the thimble. There is also a case that the mold is very large or long, and the balance of the ejector rod of the injection molding machine is not enough, and the cylinder ejector will also be used.