This article mainly introduces:

Azerbaijan hydraulic cylinder,rack cylinder manufacturer,rack cylinder

(Azerbaijan rack cylinder,produced by Hengyu Hydraulic Co., Ltd）

rack cylinder are widely used in Azerbaijan，because of no need for deceleration device，long service life，smooth movement.So our company has designed rack cylinder for customers from Azerbaijan.

Introduction to rack cylinder:

The definition of the minimum starting pressure of the rack cylinder refers to the minimum working pressure of the rack cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the rack cylinder parts and the size of the sealing friction.

Do not enter foreign bodies when installing the rack cylinder block. The place where the installation operation is carried out, the conditions are not good, and foreign bodies can be entered unconsciously. Therefore, the installation site must be cleaned up around, especially the place where the parts are placed must be cleaned, so that there is no dirt.

The rack cylinder should be vented: when the rack cylinder is installed or parked for a long time to work again, the air will penetrate into the rack cylinder and the pipeline system. In order to prevent the abnormal phenomenon of crawling, noise and heating of the actuator, the air in the rack cylinder and the system should be discharged. In order to facilitate the removal of air deposited in the rack cylinder, the oil is best entered and discharged from the highest point of the rack cylinder. rack cylinders that require higher motion stability are often equipped with exhaust plugs at both ends. Before working, unscrew the exhaust plug to make the piston go back and forth several times without load in the whole stroke, and the air can be discharged through the exhaust plug. After the air is drained, tighten the exhaust plug before working.

Repair method of small range wear of oil rack cylinder: 1. Use oxygen-acetylene flame to bake the scratched part (master the temperature, avoid surface annealing), bake the oil on the metal surface all the year round until no sparks splash; 2. The scratched part is treated with an Angle grinder, the grinding depth is more than 1 mm, and the groove is polished along the guide rail, preferably a dovetail groove. Scratch both ends of the drilling deeper, change the force situation; 3. Clean the surface with absorbent cotton dipped in acetone or anhydrous ethanol.

Answers to some questions about rack cylinder:

What is the meaning of cylinder HSGK01-100/70E-4111-1320?
hsg Double acting single piston rod hydraulic cylinder and front end cover are connected by internal clamp key 01 Design serial number 100 cylinder inner diameter 70 piston rod outer diameter e Pressure class code 16mpa4111 Front flange, rod end external thread, both ends with buffer, oil port connection is internal thread 1320 stroke.

How does the cylinder work?
Hydraulic transmission principle: oil as the working medium, through the change of the sealing volume to transfer movement, through the internal pressure of the oil to transfer power. 1. The power part - converts the mechanical energy of the prime mover into the pressure energy of the oil (hydraulic energy). For example: hydraulic pump. 2, the executive part - the hydraulic pump input oil pressure energy into the mechanical energy to drive the working mechanism. For example: hydraulic cylinder, hydraulic motor. 3, the control part - used to control and adjust the oil pressure, flow and flow direction. For example: pressure control valve, flow control valve and direction control valve. 4, the auxiliary part - the first three parts are connected together to form a system, which plays the role of oil storage, filtration, measurement and sealing.